收藏本站
LTC3215
OPERATION
–
Regulation is achieved by sensing the voltage at the CPO
pin and modulating the charge pump strength based
on the error signal. The CPO regulation voltages are set
internally, and are dependent on the charge pump mode
as shown in Table 1.
1.5V IN
OR
2V IN
+
R OL
3215 F01
+
CPO
–
Table 1. Charge Pump Output Regulation Voltages
CHARGE PUMP MODE
1.5x
V CPO
4.6V
Figure 1. Charge Pump Open-Loop Thevenin-Equivalent Circuit
2x 5.1V
In shutdown mode all circuitry is turned off and the
LTC3215 draws a very low current from the V IN supply.
Furthermore, CPO is weakly connected to V IN . The LTC3215
enters shutdown mode when the EN pin is brought low.
Since EN is a high impedance CMOS input it should never
be allowed to float. To ensure that its state is defined, it
must always be driven with valid logic levels.
Thermal Protection
The LTC3215 has built-in overtemperature protection.
Thermal shutdown circuitry will shutdown the I LED output
when the junction temperature exceeds approximately
150°C. It will re-enable the I LED output once the junc-
tion temperature drops back to approximately 135°C.
The LTC3215 will cycle in and out of thermal shutdown
indefinitely without latch up or damage until the heat
source is removed.
Soft-Start
To prevent excessive inrush current during start-up and
mode switching, the LTC3215 employs built-in soft-start
circuitry. Soft-start is achieved by increasing the amount
of current available to the output charge storage capacitor
linearly over a period of approximately 250μs.
Charge Pump Strength
When the LTC3215 operates in either the 1.5x mode or 2x
mode, the charge pump can be modeled as a Thevenin-
equivalent circuit to determine the amount of current
available from the effective input voltage and effective
open-loop output resistance, R OL (Figure 1).
R OL is dependent on a number of factors including the
oscillator frequency, flying capacitor values and switch
resistances.
From Figure 1, we can see that the output current is
proportional to:
(1.5V IN – CPO)/R OL or (2V IN – CPO)/R OL (2)
in the 1.5x mode or 2x mode respectively.
LED Current Programming
The LTC3215 includes an accurate, programmable cur-
rent source that is capable of driving LED currents up to
350mA continuously and up to 700mA for pulsed opera-
tion. Pulsed operation may be achieved by toggling the
EN pin. In either continuous or pulsed operation, proper
board layout is required for effective heat sinking.
The current may be programmed using a single external
resistor. Equation 1, used to calculate the resistor value
from the desired current level is repeated below:
R SET = 3990/I LED (1)
For applications requiring multiple current levels, several
schemes may be used to change the resistance for the R SET
resistor. Figure 2 shows two such schemes. The circuit
in Figure 2a uses the I/O output of a microcontroller to
switch a second resistor (R2) in parallel or series with R1,
changing the effective I SET current. Alternatively, the circuit
in Figure 2b uses a pulse-width modulator (PWM) to vary
the current through R SET , which changes the LED current.
3215fc
7
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LTC3217EUD#TRPBF IC LED DRVR FLASH TORCH 16QFN
LTC3218EDDB#TRPBF IC LED DRVR FLASH TORCH 10DFN
LTC3219EUD#PBF IC LED DRIVR QVGA DISPLAY 20-QFN
LTC3220EPF#PBF IC LED DRVR QVGA DISPLAY 28UTQFN
LTC3230EUD#PBF IC LED DRIVR WHITE BCKLGT 20-QFN
LTC3452EUF#TRPBF IC LED DRIVER PHOTO FLASH 20-QFN
LTC3453EUF#TRPBF IC LED DRIVER PHOTO FLASH 16-QFN
LTC3454EDD#TRPBF IC LED DRIVER PHOTO FLASH 10-DFN
相关代理商/技术参数
LTC3215EDD#TR 功能描述:IC LED DRIVR WHITE BCKLGT 10-DFN RoHS:否 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3215EDD#TRPBF 功能描述:IC LED DRIVR WHITE BCKLGT 10-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3216 制造商:LINER 制造商全称:Linear Technology 功能描述:700mA Low Noise High Current LED Charge Pump
LTC3216EDE 制造商:Linear Technology 功能描述:LED DRVR 1Segment 3.3V 12-Pin DFN EP
LTC3216EDE#PBF 功能描述:IC CHARGE PUMP LED 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件
LTC3216EDE#TRPBF 功能描述:IC CHARGE PUMP LED 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件
LTC3217 制造商:LINER 制造商全称:Linear Technology 功能描述:600mA Low Noise Multi-LED Camera Light Charge Pump
LTC3217EUD 制造商:Linear Technology 功能描述:LED DRVR 4Segment 3.3V 16-Pin QFN EP